Oregon Scientific SE188 User Manual download pdf (Page 15)

• Check the batteries. If they are low or exhausted,

the transmission range may be shortened.

• Force a signal search (see “Signal Search” section).

2. The gym equipment does not seem to work with your

chest belt and the digital icon is displayed:

• Most gym equipment is compatible with the

analog system . Press and hold the chest belt

button for more than 4 seconds to change from

digital to analog. Then force a signal search

(see “Signal Search” section).

3. Interference from another person’s heart rate monitor

- their heart rate readings appear on your watch, or the

heart rate monitor shows “0”:

• Press the chest belt button to get the watch to

receive your chest belt signal. Do not press and

hold the chest belt button, as it will change the

transmission signal from digital to analog.

4. The signal is jammed - the heart rate reading on your

watch is ﬂashing:

• There is too much interference in the

environment for your heart rate monitor to

function. Move to an area where the heart

rate reading stops ﬂashing.

WARNING Signal interference in the environment can be

caused by electromagnetic disturbances. These may occur

near high voltage power lines, trafﬁc lights, overhead lines

of electric railways, electric bus lines or trams, televisions,

car motors, bike computers, some motor driven exercise

equipment, cellular phones or when you walk through

electric security gates. Under interference, the heart rate

reading may become unstable and inaccurate.

SIGNAL SEARCH

To force a signal search:

1. Press MODE to navigate to the SMART TRAINING

PROGRAM or Stopwatch Mode.

2. Press and hold MODE for 2 seconds. The signal-

searching icon with the outside ﬂashing will appear to

conﬁrm a signal search is taking place. Whenever the

watch is searching for the chest belt signal make sure

that the chest belt is no further than 10 cm (4 inches)

from the watch.

The signal search will take approximately 10 seconds. If

after 10 seconds the heart icon is not ﬂashing, then your

signal search has been unsuccessful and you need to force

another signal search.

See the table in the “Transmission Signal” section for more

signal status information.

ABOUT THE SMART TRAINING PROGRAM

The SMART TRAINING PROGRAM enables you to

complete exercise cycles effectively. It will guide you through

from a 5-minute warm up (default setting), to the end of your

exercise program. In addition to monitoring your heart rate

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments

Oregon Scientific SE188 User Manual Page 15

Comments to this Manuals

Related products and manuals for Heart rate monitors Oregon Scientific SE188